Had good luck so far on support in certain cases, but cannot seem to get skeinforge to kick out the right g-code for this model.

http://www.thingiverse.com/thing:71279

It is for the X Idler side (the motor side I am sure will be the same). The clamps which hold the x rods in place. The clamp part is free floating in that orientation. Skeinforge is generating support up through the bolt hold, but not on the part to support the free floating area.

I get support in the z threaded rod support area too. So it is generating support just not in the right places.

I may need to take the Open SCAD and just add a .5 mm wall in there to hold it, but was hoping the support would generate.

Any ideas on what may be missing in the settings?

Thanks!

Randy