[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 678: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4755: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3887)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4757: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3887)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4758: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3887)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4759: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3887)
Open Lab Idaho Forums :: View topic - Skeinforge Support Material Settings
Open Lab Idaho Forums
https://forums.openlabidaho.org/

Skeinforge Support Material Settings
https://forums.openlabidaho.org/viewtopic.php?f=10&t=408
Page 1 of 1

Author:  steinra [ Thu Aug 15, 2013 5:04 pm ]
Post subject:  Skeinforge Support Material Settings

Had good luck so far on support in certain cases, but cannot seem to get skeinforge to kick out the right g-code for this model.

http://www.thingiverse.com/thing:71279

It is for the X Idler side (the motor side I am sure will be the same). The clamps which hold the x rods in place. The clamp part is free floating in that orientation. Skeinforge is generating support up through the bolt hold, but not on the part to support the free floating area.

I get support in the z threaded rod support area too. So it is generating support just not in the right places.

I may need to take the Open SCAD and just add a .5 mm wall in there to hold it, but was hoping the support would generate.

Any ideas on what may be missing in the settings?

Thanks!

Randy

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/