Open Lab Idaho Forums
https://forums.openlabidaho.org/

Simplify3D
https://forums.openlabidaho.org/viewtopic.php?f=7&t=448
Page 1 of 1

Author:  garyacrowellsr [ Sun Jan 26, 2014 8:59 pm ]
Post subject:  Simplify3D

Dunno if you guys have seen or heard anything about Simplify3D - it's a newish slicer and control program. Very fast slicer, and gives very good control over supports and infill, and includes a mesh fixer. Looks like it'll configure pretty easily to any printer.

Anyway, I bought a copy (yeah, it's not open), and I'll bring it to the lab on Wednesday, assuming nothing else interferes.

Gary

Author:  steinra [ Wed Jan 29, 2014 2:15 pm ]
Post subject:  Re: Simplify3D

Look forward to seeing it. What is the cost on it?

Thanks!

Randy

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/